Intermediate (field), (direct and General Support) and Depot Level Maintenance: Generator Set, Aviation, Gas Turbine Engine Driven, Integral Trailer Mounted, 10KW, 28 Volts : DoD Model MEP 362A, Class Precise, Mode DC, NSN 6115-01-161-3992 (Google eBook)
Departments of the Army, Air Force, Navy and Headquarters U.S. Marine Corps, 1989 - Gas-turbines
What people are saying - Write a review
We haven't found any reviews in the usual places.
accordance with paragraph AIR FORCE T0 Aline bearing bleed air bolts cable plug connector card paragraph l0-2b CAUTION To prevent circuit card paragraph combustion chamber compressor inlet housing cont contactor Continued Nomenclature Reference CONTROL MODULE EECM control panel diode Disassembly electrical ELECTRONIC CONTROL MODULE ENGINE ELECTRONIC CONTROL engine housing access ensure Fabricated Tools figure fuel injection GEARBOX ASSEMBLY GECM go to Step housing access cover inch pounds l.5 Vdc labyrinth seal lockbolts lockring lockwashers Loosen turnlock fasteners MARINE CORPS TM microprocessor Move MASTER SWITCH nondestructive test NSN Material required ohmmeter power supply preformed packing prevent injury REMOVAL AND INSTALLATION Remove screws Remove tags Repair or replace replace as necessary Resistor secure with turnlock secure with washers shouldered shaft solenoid valve spacer spur gear starter switch circuit card Tag and disconnect thermocouple Tools and Equipment Torque TURBINE ASSEMBLY turbine wheel voltage is less voltmeter VOLTS WARNING To prevent
Page 13-20 - Storage8 (referenced in MIL-STD-649 and applies only to direct shipments to Department of Defense agencies). MIL-STD-410 Nondestructive Testing Personnel Qualification and Certification (Eddy Current, Liquid Penetrant, Magnetic Particle, Radiographic and Ultrasonic)8 MIL-STD-649 Aluminum and Magnesium Products, Preparation for Storage and Shipment* 2.1.4 Federal Standard: Fed.
Page 2-55 - Technical," and was useful as a "solvent for fats, oils, varnishes, waxes, resins"; the label stated, further, that the product should be used "with adequate ventilation," that "prolonged or repeated breathing of vapor" and "prolonged or repeated contact with skin" should be avoided, and that the product should not be taken internally. It was shown that decedent had read the label before using the chemical. On appeal from a judgment in plaintiff's favor, defendant's...
Page 8-2 - Blistering Raised areas indicating separation of the surface from the base. Usually found on plated or painted surface.
Page 8-2 - Improper assembly or disassembly technique, such as removing or installing a roller or ball bearing by pressure on free race.