Proceedings of the American Society of Civil Engineers, Volume 29, Part 1 (Google eBook)

Front Cover
American Society of Civil Engineers., 1903 - Civil engineering
0 Reviews
Vols. for Jan. 1896-Sept. 1930 contain a separately page section of Papers and discussions which are published later in revised form in the society's Transactions. Beginning Oct. 1930, the Proceedings are limited to technical papers and discussions, while Civil engineering contains items relating to society activities, etc.
  

What people are saying - Write a review

We haven't found any reviews in the usual places.

Common terms and phrases

Popular passages

Page 33 - Test pieces should be broken as soon as they are removed from the water. Care should be observed in centering the briquettes in the testing machine, as cross,strains, produced by improper centering, tend to lower the breaking strength.
Page 33 - The neck has a diameter of about 9 mm. (0.35 in.), and is graduated into tenths of cubic centimeters above the mark F.
Page 33 - ... dry. The mixing should be done on some non-absorbing surface, preferably plate glass. If the mixing must be done on an absorbing surface it should be thoroughly dampened prior to use.
Page 33 - A moist closet consists of a soapstone or slate box, or a metal-lined wooden box the metal lining being covered with felt and this felt kept wet. The bottom of the box is so constructed as to hold water, and the sides are provided with cleats for holding glass shelves on which to place the briquettes. Care should be taken to keep the air in the closet uniformly moist.
Page 33 - ... cm. (0.39 in.) in diameter, the cap, rod and cylinder weighing 300 gr. (10.58 oz.). The rod, which can be held in any desired position by a screw (F) carries an indicator, which moves over a scale (graduated to centimeters) attached to the frame (K). The paste is held by a conical, hard-rubber ring (I), 7 cm.
Page 33 - ... and the smaller end smoothed off with a trowel; the paste, confined in the ring, resting on the plate, is placed under the rod bearing the cylinder, which is brought in contact with the surface and quickly released.
Page 33 - ... and cover attached, is held in one hand in a slightly inclined position, and moved forward and backward, at the same time striking the side gently with the palm of the other hand, at the rate of about 200 strokes per minute. The operation is continued until not more than one-tenth of 1 per cent passes through after one minute of continuous sieving.
Page 33 - All proportions should be stated by weight; the quantity of water to be used should be stated as a percentage of the dry material.
Page 33 - In the present state of our knowledge it cannot be said that cement should necessarily be condemned simply for failure to pass the accelerated tests; nor can a cement be considered entirely satisfactory simply because it has passed these tests.
Page 33 - ... long; in the middle of this neck is a bulb (C), above and below which are two marks, F and E; the volume between these marks is 20 cu. cm. (1.22 cu.

Bibliographic information