Development of oil-in-water monitor: phase II, Volume 1

Front Cover
Environmental Monitoring and Support Laboratory, Office of Research and Development, U.S. Environmental Protection Agency, 1980 - Technology & Engineering - 37 pages
0 Reviews
 

What people are saying - Write a review

We haven't found any reviews in the usual places.

Common terms and phrases

Popular passages

Page ii - This report has been reviewed by the US Environmental Protection Agency and approved for publication. Approval does not signify that the contents necessarily reflect the views and policies of the Environmental Protection Agency, nor does mention of trade names or commercial products constitute endorsement or recommendation for use.
Page ii - Laboratory, US Environmental Protection Agency, and approved for publication. Approval does not signify that the contents necessarily reflect the views and policies of the US Environmental Protection Agency, nor does mention of trade names or commercial products constitute endorsement or recommendation for use. FOREWORD...
Page iii - Investigate methods for the concentration, recovery, and identification of viruses, bacteria, and other microbiological organisms in water. Conduct studies to determine the responses of aquatic organisms to water quality.
Page iii - ... use. FOREWORD Environmental measurements are required to determine the quality of ambient waters and the character of waste effluents. The Environmental Monitoring and Support Laboratory...
Page vii - Portions of the reported work were conducted in the facilities of the US Army Fuels and Lubricants Research Laboratory located at Southwest Research Institute. This laboratory is operated under contract for the US Army Mobility Equipment Research and Development Command at Ft.
Page 7 - Figure 2) strikes the boundary between the core and the cladding at an angle greater than the critical angle so that total internal reflection occurs.
Page 21 - Figure 8 it is evident that the detection threshold for n-hexylbenzene is about 2 mg/L; for tetralin, approximately 30 mg/L; and for p-xylene, slightly greater than 400 mg/L.

Bibliographic information