QC/T 29106-2014: Translated English of Chinese Standard. (QCT 29106-2014, QC/T29106-2014, QCT29106-2014): Technical Specification of Automobile Wire Harness
https://www.chinesestandard.net, 18.10.2016 г. - 45 страници
This Standard specifies the requirements, test methods, inspection rules, marking, packaging, storage and custody of automobile wire harnesses.
Какво казват хората - Напишете рецензия
Не намерихме рецензии на обичайните места.
Annex B Normative Heatshrinkable Doublewall Tubes for Automobile Wire
Други издания - Преглед на всички
actual products area of conductor Automobile Wire Harnesses Changchun Clip Conduct the test conductor crimping area Connecting bar Connecting zone connection of terminals Crimp connection crimping juncture dimensions drawings and technical drop between measuring embranchment points Entrance curve factory-exit inspection harnesses shall meet heat-shrinkable double-wall tubes heat-shrinkable tubes inspection items Insulation Crimping JB/T linear interpolation Lock device main stem measuring points meet the requirements Mopeds QC/T Motorcycles and Mopeds Nominal sectional area partition board Polyamide polyolefin pressure-sensitive adhesive tape Protection sleeve published by China requirements of 4.2 requirements of Annex requirements of GB/T requirements of Table Road Vehicles Rubber saline solution samples from actual seal plug sensitive adhesive tape shown in Figure standards were published Stranded Wire Take samples tear force technical documents tensile force Tensile strength terminal crimping terminals and wires test according Test facility Test Methods Test sample type inspection waterproof wire conductor Wire end Wire Tape