QC/T 417.2-2001 Translated English of Chinese Standard. (QCT 417.2-2001, QC/T417.2-2001, QCT417.2-2001): Road vehicles - Connections for on-board electrical wiring harnesses - Part 2: Test methods and general performance requirements (motorcycle part)https://www.chinesestandard.net, 2019年6月18日 - 21页 This standard specifies the definition, test methods, performance requirements for connections of single-wire harness and multi-wire harness of low-voltage cable (wire) used in the electrical circuit of motorcycles and mopeds. This standard applies to connectors of chip and column type. Other types of connectors may also make reference to this standard. |
常见术语和短语
10th pullout force 1st maximum insertion affect the connection categorized test temperature conductor reel connection piece Connections for on-board connector into shell connector is crimped connector of single-wire Contact resistance voltage Conversion factor Crimp connection current cycle eqv IEC follow the sequence force of connector GB/T insertion/pullout force inside the equipment Insulation dielectric strength insulation reel JB/T Maintain the temperature mating connector metal foil mm/min multi-wire connectors nominal cross-section pair of connectors performance requirements point Measuring point pullout direction QC/T range of 50 relative humidity required by Table requirements of Table resistance voltage drop Retaining force Sealed connector sequence as required sequence of Table shell cavity shown in Figure specified in Table specimen groups Splash-proof connector subsequent tests temperature inside test according test current test equipment test methods test report test sequence unless otherwise specified ventilation and manual vibration test Visual inspection Water-tightness wire as crimped wire-wire connection