QC/T 818-2009 Translated English of Chinese Standard. (QCT 818-2009, QC/T818-2009, QCT818-2009): Spoke-wheels of motorcycles and mopedshttps://www.chinesestandard.net, 2015 M04 18 - 24 pages This Standard specifies the terms and definition, requirements, test methods, inspection rules, label, package, transportation, and storage of spoke-wheels of motorcycles and mopeds. This Standard is applicable to the spoke-wheels of motorcycles and mopeds. |
Contents
Foreword | 6 |
Scope | 7 |
Terms and definitions | 8 |
Requirements | 9 |
Test methods | 12 |
Inspection rules | 21 |
Label package transportation and storage | 23 |
Common terms and phrases
ADOPT visual inspection Air tightness aluminum alloys GB/T Automobile Industry Standards axial circle run-out back wheel bead seat rim calibrated diameter calibrated perimeter cracks after test detector to inspect Diameter of spoke double hammer exit-factory inspection forged hub height of fall hub shall conform hub spoke hole impact hammer Industry and Information Information Technology installed main hammer Mechanical performance mopeds QC/T motorcycles and mopeds penetration flaw detector quality of forged radial and axial radial impact test Radial load fatigue requirements in GB/T rotating drum run-out of wheel screw thread sensor for automobile shown in Figure single hammer Snow blower specified in GB/T spoke and spoke spoke nut Spoke-wheels of motorcycles support hammer surface of brake tension of hub tension of spoke terms and definitions textile industry standard tightening torque torque of spoke type inspection Ultimate Tension Values Weight of impact wheel is 1.0 width of rim X-ray fault detector