Journal of Engineering for Industry, Volume 90American Society of Mechanical Engineers, 1968 - Electronic journals |
Contents
Temperature Responses and Experimental Errors for Multitooth Milling Cutters | 6 |
Plastic Instability in Simple Stretching of Sheet Metals 67WAProd12 | 12 |
The Influence of Redundant Work When Drawing Rods Through Conical Dies | 455 |
Other editions - View all
Common terms and phrases
analysis angle applied approximately ASME assumed axial axle bending boundary calculated cell chip Combined components considered constant cost curve cutting cylinder deflection deformation determined developed direction displacement distribution drill dynamic edge effect Engineering equation experimental expressed factor flow force frequency friction function given heat increase indicated initial Journal layer length limit load machine material maximum mean measured mechanism metal method normal obtained occur operation parameters percent pipe plane plastic plate position possible presented pressure problem production radius range ratio reduced reference relation relative shear shown in Fig shows solution specimen speed steel strain stress surface Table temperature thickness tion tool tooth unit values variations wear weight wheel yield