19 pages matching second chucking in this book
Results 1-3 of 19
What people are saying - Write a review
We haven't found any reviews in the usual places.
bar stock boring boring-bar mounted box-tool bushing cast iron casting chamfer chuck jaws chuck plate clamps clutch cone counterbore cross-slide cutter held cutter mounted cylinder diameter drill employed facing head mounted finish-bored finish-faced flange flat turret lathe flywheel forming tool Friction gear blank Gisholt turret lathe groove held in Face held in Side hole illustrated in Fig indicated Machinery Fig method minutes mounted in Face mounted in Side multiple turning head operations performed piece pilot piston pulley reamed reamer mounted rear revolutions per minute rough-bored rough-faced by tool screw machine second chucking second operation second sequence sequence of operations shown in Fig side-head turret sleeve spindle square turret Steam Trap surface F tapered surface threaded three-jaw chuck tool bit tool F tool held tool lay-out tool-block tool-holder tooling equipment tools mounted total time required turned by cutter turret face turret toolpost various steps