International Residential Code for One- and Two-family Dwellings |
From inside the book
Results 1-3 of 62
Page 235
... rafters , rafter ties shall be nailed to the rafter near the plate line and spaced not more than 4 feet on center . FIGURE R802.5.1 BRACED RAFTER CONSTRUCTION TABLE R802.11 REQUIRED STRENGTH OF TRUSS OR RAFTER TIE -. TOP PLATE RAFTER ...
... rafters , rafter ties shall be nailed to the rafter near the plate line and spaced not more than 4 feet on center . FIGURE R802.5.1 BRACED RAFTER CONSTRUCTION TABLE R802.11 REQUIRED STRENGTH OF TRUSS OR RAFTER TIE -. TOP PLATE RAFTER ...
Page 240
International Code Council. RAFTER SPAN WITHOUT RAFTER SUPPORT BRACE RIDGE MEMBER- SEE FIGURE R804.3.3.1 6 IN . MAX . TO CENTER OF SCREW PATTERN CEILING JOIST SPAN LOAD - BEARING WALL SHALL BE INSTALLED WHEN RAFTER BRACE IS USED TABLE ...
International Code Council. RAFTER SPAN WITHOUT RAFTER SUPPORT BRACE RIDGE MEMBER- SEE FIGURE R804.3.3.1 6 IN . MAX . TO CENTER OF SCREW PATTERN CEILING JOIST SPAN LOAD - BEARING WALL SHALL BE INSTALLED WHEN RAFTER BRACE IS USED TABLE ...
Page 243
... rafter support brace shall be a minimum of 350S162-33 C - section with maximum length of 8 feet ( 2438 mm ) and shall be connected to a ceiling joist and rafter with four No. 10 screws at each end . R804.3.3.1 Rafter framing . Rafters ...
... rafter support brace shall be a minimum of 350S162-33 C - section with maximum length of 8 feet ( 2438 mm ) and shall be connected to a ceiling joist and rafter with four No. 10 screws at each end . R804.3.3.1 Rafter framing . Rafters ...
Other editions - View all
International Residential Code for One- and Two-Family Dwellings: Turbo Tabs International Code Council No preview available - 2003 |
Common terms and phrases
12 inches accor accordance with Section accordance with Table air admittance valve appliance applied approved ASTM braced wall line braced wall panels ceiling joists clearance combustion air comply concrete conductors connected construction dead load diameter draft hood drain drainage ducts equipment exceed exterior walls FAN NAT FAN fastened feet FIGURE fireplace fixture floor flue furnace grade Ground snow load grout heaters height horizontal installed in accordance insulating concrete form insulation International Building Code joints joists kN/mē less LINTEL listed and labeled located manufacturer's installation instructions masonry material maximum metal mile per hour minimum nail NAT FAN NAT opening outlet permitted piping material pound per square pressure R-value reinforcement roof screws Seismic Design Categories sheathing slope Southern pine space square foot square inch studs thickness tion Type units valve vent connector venting system vertical wall studs wind speed Wood shingles wood structural panel