The Complete Handbook of Power Tools |
From inside the book
Results 1-3 of 32
Page 339
George R. Drake. To crosscut , place the miter in a miter groove in the table top , and set the gauge to 90 ° ( this is 0 ° on some miter gauges at any rate , the miter head is perpendicular to the blade ) . Set the blade to the correct ...
George R. Drake. To crosscut , place the miter in a miter groove in the table top , and set the gauge to 90 ° ( this is 0 ° on some miter gauges at any rate , the miter head is perpendicular to the blade ) . Set the blade to the correct ...
Page 341
... miter gauge unless it is being used . In lieu of the stop rod on the miter gauge , stop blocks can be used . Refer to Sec . 1-12 . Duplicate sized workpieces can be cut using the miter gauge stop rod to determine the size of the ...
... miter gauge unless it is being used . In lieu of the stop rod on the miter gauge , stop blocks can be used . Refer to Sec . 1-12 . Duplicate sized workpieces can be cut using the miter gauge stop rod to determine the size of the ...
Page 342
George R. Drake. Miter Cuts Use the same procedures for making miter cuts as for making crosscuts , except set the miter gauge to the required angle ( Fig . 11-7 ) . Hold the workpiece very firmly to the miter gauge head , and feed ...
George R. Drake. Miter Cuts Use the same procedures for making miter cuts as for making crosscuts , except set the miter gauge to the required angle ( Fig . 11-7 ) . Hold the workpiece very firmly to the miter gauge head , and feed ...
Contents
workshopsbasement attic or garage? 8 14 workshop floor plans 9 | 9 |
electrical power 12 16 lighting the work area 12 17 motors belts pulleys | 34 |
and adjustments 49 24 operation 50 25 sawing procedures 52 | 52 |
Copyright | |
13 other sections not shown
Common terms and phrases
abrasive belt accessories alignment arbor attached band saw belt sander bevel bolt carriage chisel chuck clamp collar countersink crosscut cutter cutting head dado head depth of cut desired diameter disk sander drill press drive pulley edge faceplate feed the workpiece FIGURE flat groove guard headstock height hold down fingers hold the workpiece hole inches infeed fence installed jigsaw jointer kerf knives lathe located loosen lower metal miter gauge molding head mortising motor mounted operations outfeed fence piece Place the workpiece plane platen position power tool procedures pulley quill rabbeting radial arm saw rear table Refer to Sec remove rev/min rip cut rip fence rip sawing roller rotate router sander-grinder sanding saw blade scrap wood screw Set and lock setscrew shaft shaping side slot speed spindle straight surface table saw table tilt tailstock taper tension thickness planer tighten tilting table tool rest wheel width workpiece firmly yoke