Direct Support and General Support Maintenanc Manual: Teletypewriter Sets, AN/PGC-1, (NSN 5815-00-198-5963), AN/PGC-3, (NSN 5815-01-012-8773) and Teletypewriters, TT-4A/TG, (NSN 5815-00-198-4438) ...
Departments of the Army and Air Force, 1976 - Teletype
What people are saying - Write a review
We haven't found any reviews in the usual places.
Adjustment TT-4B/TG armature ball bearing bell crank cam follower camshaft capacitor carriage carriage-feed carriage-return clutch carriage-return operating check the requirement clamping screw clearance code group code impulses code rings code-ring cage contact lever cotter pin counterclockwise detent Disassembly and Reassembly disassembly sequence driving gear eccentric end-play adjustment Exploded View feeler gage Felt lubricating washer figures-shift Flat washer function shaft function-cam function-selecting arm keyboard keyboard-transmitter keylever letters-shift LINE FEED line-feed locking-bail lockwashers that hold Loosen the setscrews Machine screw manual carriage-return mechanism Method of Checking motor-stop mounting screws moves paper-shaft bracket pawl Plain hexagonal nut platen platen-shift position punch bar rangefinder Remove the machine Remove the retainer Replace restoring roller Retainer ring ribbon ribbon-reverse rotate selector lever selector-lever Selector-magnet Self-locking hexagonal nut sensing lever sensing-lever sequence for assembling setscrews shaft assembly signal-bell spacing stop bar switch teletypewriter terminal board Test transmitter camshaft type-selecting arm washers that hold Y-lever
Page 2-3 - Special code in which each code group is made up of five units, or elements, of equal length which are known as marking or spacing impulses. The five-unit start-stop code consists of five signal impulses preceded by a start impulse and followed by a stop impulse. Each impulse except the stop impulse is 22 milliseconds in length: the stop impulse is 32 milliseconds (based on 60-words-per-minute operation.) telewriter— System in which writing movement at the transmitting end causes corresponding...
Page 4-2 - The performance standards listed in the text (para 45 through 4-9) assume that current modification work orders (MWO) have been performed. Any MWO's pertaining to this equipment that may have been published after the data of this publication will be listed in DA Pam 310-7 and changes thereto.
Page 3-185 - Move it to the left to decrease, and to the right to increase the pulse length: tighten the screws and recheck the signal length.